You are not logged in or registered. Please login or register to use the full functionality of this board...

Latest news: --- spanishestimate07.2018 --- Locked13 --- Delphi 2015.3 Full + Activator [Multilanguage] --- Need dump Seat alana card radio 24l16 --- FORD IDS 109.01 --- service ranger keygen --- Peugeot 106 R & ECM Titanium driver --- dashboard dump file --- Carly for Toyota v1.46 (Update 05.07.18) no Root --- Scania Multi 10-2017 ---

Automotive Diagnostic Tool

Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
carprog easy way to flash for newbie
03-08-2018, 08:15 PM
Post: #1
carprog easy way to flash for newbie
Hi.I did all the tutorials that concern the flashing of the carprog but
everything was not clear. I tried the method that I posted to you. It is
functional, I just simplified and modify the procedure of flashing so
that it is simple for novices (I am one myself) .I did not invent
anything or create, I just observed and tested the different methods to
get to something simple.
1) No need to unsolder AT88SC.
2) not need to lift pin 55 or solder a wire on the pin 55 (according pcp) .
3) the reset this done on a single pin as in the photo.
4) photos of the connector that I made.
I did you not put the flashing procedure (there is a lot ofpost about it).
I use the segger software "flash V 4.98" and of course
the segger interface jlink .PS look at the photos and make sure you have
the same pcb.have a good flashing.si you have questions, do not
hesitate.

If it was useful to you press thank


Attached File(s)
carprog easy way To flash.zip
File Type: .zip
Downloaded: 111 times
Size: 9.25 KB


habbou, proud to be a member of GarageForum since Feb 2015.
Visit this user's website Find all posts by this user
Quote this message in a reply
 Thanks given by: VLStelios , david123 , belkor , Baron , makmoer , goerri31 , autobuggy , volvo1111 , jonnybgud200 , dom86 , drto
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)