J2534 Pass thru and HIM

[cortez]

Hi,



I have HIM double board clone (apparently good one) which works perfectly fine in HDS.



However, does this tool support J2534 pass thru so I can update ECU on
2004 Accord? I'm trying to use it but I doesn't seem to detect.



If not, what is the cheapest working option?



Many thanks.

[Ejaikbros]

Good cheap option is allscanner vxdiag multi 3 in 1. http://www.vxdiagshop.com

Sent from my BLN-L21 using Tapatalk

[fraze]

(02-14-2020 04:49 AM)cortez Wrote:  Hi,



I have HIM double board clone (apparently good one) which works perfectly fine in HDS.



However, does this tool support J2534 pass thru so I can update ECU on
2004 Accord? I'm trying to use it but I doesn't seem to detect.



If not, what is the cheapest working option?



Many thanks.

The firmware needs to be correct with software you can update by power Him connect power OBD port & PC open HDS and I think Green button on him starts process leds will flash been few years since I use . I have VCM2 works well

[sg1oneill]

(05-03-2020 05:28 PM)fraze Wrote:  

(02-14-2020 04:49 AM)cortez Wrote:  Hi,



I have HIM double board clone (apparently good one) which works perfectly fine in HDS.



However, does this tool support J2534 pass thru so I can update ECU on
2004 Accord? I'm trying to use it but I doesn't seem to detect.



If not, what is the cheapest working option?



Many thanks.

The firmware needs to be correct with software you can update by power Him connect power OBD port & PC open HDS and I think Green button on him starts process leds will flash been few years since I use . I have VCM2 works well

I am not really get what you try to explain here but I read all around the HDS + PC setup not able to programming any control module. Only the tablet version and some kind of old pocket tester thing...

I want to buy a HDS (after market one) but I am afraid of that I cannot use to re-program my Accord modules.

Any solution from someone? Who knows 100% I can program the modules?
Thanks guys.

[kbaksh555]

Thanks guys.

[Ejaikbros]

Buy Fly100 Generation 2. It can program PCM, Keys, Smart Keys etc without demanding for pin code. I use it. 100% working.

Sent from my BLN-L21 using Tapatalk

[Chesteasy]

(02-14-2020 04:49 AM)cortez Wrote:  dont forget to check your firmware update on the j2534 to see if its up to date. and also check to see which usb port works best for the j2535 from your lap top.
Hi,



I have HIM double board clone (apparently good one) which works perfectly fine in HDS.



However, does this tool support J2534 pass thru so I can update ECU on
2004 Accord? I'm trying to use it but I doesn't seem to detect.



If not, what is the cheapest working option?



Many thanks.