You are not logged in or registered. Please login or register to use the full functionality of this board...

Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
BSI JC BSI04EV K05-00 need flash
02-28-2018, 05:11 AM (This post was last modified: 02-28-2018 05:18 AM by malguy.)
Post: #1
Peugeot BSI JC BSI04EV K05-00 need flash
I killed bsi JC of Peugeot 308 when reading pincode with fvdi on bench, please anyone have software sigature 7B6F
Attached below are software & hardware number.

Functional Plan No: 9664058780
Manufacturer: Johnson Controls
Functional Product No: 9666895780
Software Index: 05.02
Diagnostic Index: J
Software edition: 09.73
Software signature: 7B.6F
Software reference: 9674099880
   

Regards,

malguy, proud to be a member of GarageForum since Oct 2014.
Visit this user's website Find all posts by this user
Quote this message in a reply
03-20-2018, 03:50 PM
Post: #2
Citroen RE: BSI JC BSI04EV K05-00 need flash
(02-28-2018 05:11 AM)malguy Wrote:  Helo, BSI is not killed only in boot mod. When reading this bsi with fvdi,always put a battery charger onto vehicle and take out fuses for the lights and wipers, then it will read correctly. Start the process again but with battery charger on car, one hour later will read pin and exit from boot mode.
(02-28-2018 05:11 AM)malguy Wrote:  I killed bsi JC of Peugeot 308 when reading pincode with fvdi on bench, please anyone have software sigature 7B6F
Attached below are software & hardware number.

Functional Plan No: 9664058780
Manufacturer: Johnson Controls
Functional Product No: 9666895780
Software Index: 05.02
Diagnostic Index: J
Software edition: 09.73
Software signature: 7B.6F
Software reference: 9674099880


Regards,
Visit this user's website Find all posts by this user
Quote this message in a reply
 Thanks given by: malguy
03-20-2018, 08:55 PM
Post: #3
Peugeot RE: BSI JC BSI04EV K05-00 need flash
(03-20-2018 03:50 PM)Ultracalli Wrote:  
(02-28-2018 05:11 AM)malguy Wrote:  Helo, BSI is not killed only in boot mod. When reading this bsi with fvdi,always put a battery charger onto vehicle and take out fuses for the lights and wipers, then it will read correctly. Start the process again but with battery charger on car, one hour later will read pin and exit from boot mode.
Thanks for reply, I still looking for solutions. I read BSI on bench with steady 14V supply. Attached are fault during read pincode.    

malguy, proud to be a member of GarageForum since Oct 2014.
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)